CLICK HERE FOR THOUSANDS OF FREE BLOGGER TEMPLATES »

Nov 7, 2007

Bible cover

How to make a book/ Bible cover:

From SEW NEWS December '82/January '83 IssueBook covers to make for everyone Carol Nanninga

If you don't have a prayer of completing Uncle Avery's half-finished sweater before the holidays, a sew-fast book cover may be the answer to your Christmas traumas. This quick gift can be made in about a half hour, using fabric scraps and trims leftover from other sewing projects. The instructions below specify lace for the trim and ribbon as the tie closure, but use your imagination to customize your gift to the recipient. A birdwatcher would enjoy a cover of coated pack cloth for a well-worn manual. Instead of a ribbon tie, use nylon webbing that slips through two small metal loops or a buckle. A suedecloth cover with -an embroidered monogram in the corner makes a dignified-looking cover for a Bible or prayerbook. For a cook, use lightweight, plastic coated fabric--without interfacing--and slip it over an exotic cookbook. Dress up your mother's worn address book with a cover of synthetic leather or suede. A little girl would love her favorite book of fairytales covered in a Strawbeny Shortcake print, edged with lots of pink trim. Cover a school notebook with a sturdy denim cover piped with orange trim. Or make it from an old pair of jeans, with a back pocket centered on the front to hold pencils or notes. Use the piece of waistband with the snap closure in place of the ribbon closure. Most paperback books are 7" in height (top to bottom) but vary in thickness. If planning to cover a specific paperback or hardback book, you'll need the height and wrap-around length--the measurement from the edge of the front cover, around the spine to the edge of the back cover.

Instructions

Materials

1 cover, the height of the book plus 1 1/2 ", by the wrap-around length of the book plus 1 1/2"

1 piece of lining the same size as above, in the same or contrasting fabric

2 inside flaps, 4" wide by the height of the book plus 11/2"

1 piece fusible interfacing cut to match the main cover 2 pieces of fusible interfacing cut to fit the inside flaps

2 pieces of ribbon, about 10" each, for tie closures

1 piece of ribbon the height of the book, for a bookmark

Ruffles, piping, lace or other trim, as desired


1. Fuse the interfacing to the wrong side of the cover and the wrong side of the inside flaps.

2. Press under 1/2" on one long edge of each of the inside flaps, and machine stitch along the pressed edge. 3. Pin and baste the ruffle or piping along the edges of the cover, easing extra trim into corners, and matching the edge of the trim to the cut edge of the fabric (Figure 1).




4. Baste ribbons to the edge of the center front and back, so the loose ends trail to the middle of the cover. Baste the book marker slightly to the right of center on the upper edge of the cover (Figure 1).

Using a 1/2" seam allowance, sew only the upper and lower edge seams, keeping trim free. (Figure 3)


6. Turn inside out so the cover is on one side, lining and flaps on the other. Press.
7. Flip only the inside flap so its right side faces the right side of the main cover. Pin edge, keeping trim free. Stitch the end, using 1/2 seam allowance (Figure 4).
Repeat on other side.

0 comments that bring me joy: